Go

SikaPower®-2900 Primer

Adhesion promoter for SikaPower® Plastic Repair Products

SikaPower®-2900 Primer is a solvent-based colorless adhesion promoter to improve adhesion for SikaPower®-2900 series products.
It is specifically formulated for the treatment of bond faces prior to application of SikaPower® Plastic Repair adhesives.  

  • Easy spray application
  • Fast drying
  • Improves adhesion on a wide variety of plastic substrates
 
Contact
Go

PRODUCT BENEFITS

  • Easy spray application
  • Fast drying
  • Improves adhesion on a wide variety of plastic substrates
 

Areas of Application

SikaPower®-2900 Primer is used to improve adhesion on a broad range of different plastic substrates.
Seek manufacturer’s  advice and perform tests on original substrates before using SikaPower®-2900 Primer on materials prone to stress cracking.
This product is suitable for experienced professional users only. Tests with actual substrates and conditions have to be performed to ensure adhesion and material compatibility.  

Product Details

Typical Product Data
Chemical base

Solvent-based adhesion promoter

Color (CQP001-1)

Colorless, clear

Application temperature

5 ─ 40 °C

Application method

spray

Consumption

depending on substrate porosity

20 ml/m2 

Flash-off time

                                                                                                       minimum

                                                                                                      maximum

5 minutes A

2 hours A

Shelf life (CQP016-1)

36 months B

CQP = Corporate Quality Procedure

A) for  specific application, temperature and flash-off time may be different
B) stored in sealed container in up-right position in a dry place at ≤ 25 °C
Technical Information

IMPORTANT NOTE

SikaPower®-2900 Primer contains solvent which may dull the surface finish of some freshly applied paints. Preliminary trials must be carried out. Never apply to porous substrates since it may not dry completely and might influence the adhesive or sealant. Protect adjacent surfaces by masking where necessary.
It must not be used for tooling/smoothing of products and as a cleaning agent.

Application

Application Information

METHOD OF APPLICATION

Preparation

Surfaces must be clean, dry and free from grease, oil, dust and contaminants.

Application

Use the aerosol can and apply the primer in a thin and even coat to the surface in short bursts to avoid dripping or running of the primer.
Ideal application and surface temperature is between 15 °C and 25 °C.
SikaPower®-2900 Primer has to be applied once only.
If pre-treated area is not bonded within the maximum flash-off time, the activation process has to be repeated (once only).
Consumption and method of application depends on the specific nature of the substrates.