Go
Show all documents
Sikagard®-6060

Sikagard®-6060

Sprayable bitumen based underbody coating

Sikagard®-6060 is a durable, thixotropic, bitumen-based protective coating with very good rust-proofing and sound deadening properties. It is suitable for an effective vehicle underbody protection. The product can be sprayed haze free without any cob webbing and does not drip.
Sikagard®-6060 shows good adhesion on different paints, metal primers, metals and PVC without the need for pretreatment. A tough coating remains after drying, protecting metal from corrosion.  

  • Outstanding application properties (no running or dripping)
  • Good adhesion performance to a wide variety of substrates
  • Excellent acoustic and sound damping properties
  • Fast drying
  • Road salt resistant
  • High solid content
 
Contact
Go
Show all documents

PRODUCT BENEFITS

  • Outstanding application properties (no running or dripping)
  • Good adhesion performance to a wide variety of substrates
  • Excellent acoustic and sound damping properties
  • Fast drying
  • Road salt resistant
  • High solid content
 

Areas of Application

Sikagard®-6060 is a spray applied anti-corrosion coating for repair and protection of non-visible areas such as wheel arches and underbody parts of vehicles that do not need to be over painted.
This product is suitable for experienced professional users only. Test with actual substrates and conditions have to be performed to ensure adhesion and material compatibility.  

Product Details

Typical Product Data
Chemical base

Bitumen solution

Color (CQP001-1)

Black

Cure mechanism

Air-drying

Density (uncured)

1.1 kg/l

Solid content

65 %

Application temperature

15 ─ 25 °C

Film thickness

wet

dry

600 µm

400 µm

Tack free time

75 minutes A

Drying time

3.5 h A

Service temperature

-25 ─ 80 °C

Shelf life

24 months B

CQP = Corporate Quality Procedure

A) 23 °C / 50 % r. h.

B) storage between 5 °C and 25 °C
Technical Information

CHEMICAL RESISTANCE

Sikagard®-6060 is resistant against water, seawater, salt spray, bases and acids.

The above information is offered for general guidance only. Advice on specific applications will be given on request.

Application

Application Information

Surface preparation

Surfaces must be clean, dry and free of rust, dust and grease. Bare metal must be pre-­treated to enhance corrosion resistance (e.g. uncoated steel, etc).

Application

Sikagard®-6060 can be applied by light airless spray equipments or by air-mix guns with an air pressure of approx. 3 - 6 bar. Use either the Sika® SCP Gun (pressure cup type) or the Sika® UBC Gun (vacuum type) to apply the product.

Shake can approx. 40 times before use. Cover adjacent surfaces prior the spray process. Spray at room temperature and from a distance of approx. 25 cm in an grid motion to build up a continuous coat.
Sikagard®-6060 can be applied without dripping. If a thick layer is required, let layers dry in between. A wide variety of texture can be achieved by altering the spay technique.

Do not spray on parts of the brake, engine or exhaust system.

 

Removal

Uncured Sikagard®-6060 can be removed from tools and equipment with Sika® Remover-208 or another suitable solvent. Once dried, the material can only be removed mechanically. Hands and exposed skin shall be washed immediately using hand wipes such as Sika® Cleaner-350H or a suitable industrial hand cleaner and water.

Do not use solvents on skin.

Overpainting

Sikagard®-6060 cannot be overpainted.

Documents