Go

SikaFix®-210

Tough Polyurethane Resin for Injection Sealing and Ground Stabilization in Tunnelling and Mining

SikaFix®-210 is a fast-reacting polyurethane based resin with short gel times and high final strength.

  • High final strength
  • Foaming on contact with water (~ 3 times volume increase)
  • Very fast curing
  • Modular system with SikaFix AC-21 and SikaFix AC-21 SF
  • Easy application due to volume ratio 1:1
  • High penetration ability
  • Low initial viscosity
  • CFC- and halogen-free
  • Total solid*
* acc. to testing method of German Institute “Deutsche Bauchemie e.V.”
Contact
Go

Product Details

Sustainability / Certifications / Approvals

APPROVALS / CERTIFICATES

German KTW drinking water certificate
Product Information

Composition

2-component Polyurethane resin, solvent and CFC-free

Shelf life

12 months shelf life from date of production if stored properly in undamaged, unopened, original sealed packaging.

Storage conditions

Dry storage at temperatures from +5 °C up to +35 °C. Protect from direct sunlight and humidity.

Density

Part A:Part B:
~1.01 kg/l~1.23 kg/l

at 23 °C

Flash point

Part A:Part B:
>140 °C~250 °C

Viscosity

Part A:Part B:
~ 300 mPa∙s~ 260 mPa∙s

At 23 °C
Technical Information

Shore A hardness

~80 (3 days)

(EN 868)

Compressive strength

~ 80 ±5 N/mm2

(ISO 604)

Tensile strength in flexure

~70 N/mm2 (3 days at 23 °C)

(ISO 178)

Application

Application Information

Mixing ratio

1 : 1 parts by volume (refer to Application Instructions)

Ambient air temperature

+5 °C min. / +35 °C max.

Substrate temperature

+5 °C min. / +35 °C max.

Pot Life

~ 45 seconds (at 23 °C)

(PM 10081-11)
Application steps

MIXING

  • SikaFix®-210  is supplied in containers pre-batched according to the required mixing ratio of 1 : 1 parts by volume
  • Both components are mixed together on injection through a 2 C-injection pump, drawing each component directly from the original containers. The static mixer must be suitable to ensure that the mixture of comp. A and B forms a stable emulsion.
  • Use injection ports, lances or packers with a sufficiently large diameter and flow.

CLEANING OF EQUIPMENT

Clean all tools and application equipment according to the Product Data Sheet for the Sika®Injection Cleaning System.