Go
Show all documents

Sika® Cleaner G+M

Solvent-based cleaning agent with superior degreasing properties

Sika® Cleaner G+M is a solvent-based colorless clear cleaning agent which exhibits superior degreasing properties.  

  • Very good degreasing properties
  • Fast drying
  • Easy to use
 
Contact
Go
Show all documents

PRODUCT BENEFITS

  • Very good degreasing properties
  • Fast drying
  • Easy to use
 

Areas of Application

Sika® Cleaner G+M is used to remove foreign matter and contaminants such as grease, oil, dust and dirt from the surface. Typical substartes that may are cleaned prior to the application of adhesives and sealand are float glass, coated glass, enameled glass, anodized aluminum, polyester powder-coated metals and stainless steel. This product is suitable for experienced professional users only. Tests with actual substrates and conditions have to be performed to ensure adhesion and material compatibility.  

Advantages

  • Very good degreasing properties
  • Fast drying
  • Easy to use
 

Product Details

Typical Product Data
Chemical base

Solvent-based

Color (CQP001-1)

Colorless, clear

Application temperature

5 ─ 40 °C

Application method

Wipe-on, wipe-off with lint-free paper towel

Shelf life

48 months A

CQP = Corporate Quality Procedure

A) stored in sealed container in a dry place at ≤ 25 °C

Technical Information

IMPORTANT NOTE

Compatibility with the actual substrate is to be verified prior the application.

Discard any Sika® Cleaner G+M that loose its clear appearance (contaminated).

 

Application

Application Information

METHOD OF APPLICATION

Application

Wet the paper towel with solvent by pouring the liquid onto the towel. Never dip the towel into the cleaner as it may contaminate it!

Wipe the surface with the wetted paper towel. Use fresh paper towels regularly in order to retain the cleansing power. Before the solvent dries on the surface (evaporates), wipe it off with a clean, dry towel. Repeat the last two steps until no contaminants show up on a white paper towel.

If cleaned parts are not bonded subsequently cover them in order to prevent new contamination. In case the time between cleaning and further processing exceeds two hours, repeat the treatment as described above.

Ideal application and surface temperature is between 15 °C and 25 °C.

Use only clean, white, lint-free paper towels.

Tightly reseal container immediately after each use.

Documents