Go

Sika® Cleaner P

Solvent-based cleaning agent for non-porous substrates

Sika® Cleaner P is a solvent-based colorless clear cleaning agent for non-porous substrates.  

  • Good degreasing property
  • Easy to use
  • Fast process
 
Contact
Go

PRODUCT BENEFITS

  • Good degreasing property
  • Easy to use
  • Fast process
 

Areas of Application

Sika® Cleaner P is used to remove foreign matter and contaminants such as grease, oil, dust and dirt from the surface. Possible surfaces are glass, plastics, metals, polyester powder-coated metals and PVDF-coated metals prior to the application of sealants and adhesives. It must only be used on non-porous substrates. This product is suitable for experienced professional users only. Tests with actual substrates and conditions have to be performed to ensure adhesion and material compatibility.  

Advantages

  • Good degreasing property
  • Easy to use
  • Fast process
 

Product Details

Typical Product Data
Chemical base

Solvent-based

Color (CQP001-1)

Colorless, clear

Application temperature

5 ─ 40 °C

Application method

Wipe-on, wipe-off with lint-free paper towel

Shelf life

48 months A

CQP = Corporate Quality Procedure

A) stored in sealed container in a dry place at ≤ 25 °C

Technical Information

IMPORTANT NOTE

Compatibility with the actual substrate is to be verified prior the application.

Discard any Sika® Cleaner P that loose its clear appearance (contaminated).

Application

Application Information

METHOD OF APPLICATION

Wet the paper towel by pouring Sika® Cleaner P onto it. Never dip the towel into the cleaner as it may contaminate it.

Wipe the surface with the wetted paper towel. Use fresh paper towels regularly in order to retain the cleansing power.

Before the solvent dries on the surface (evaporates), wipe it off with a clean, dry paper towel.

Repeat the last two steps until no contaminants show up on a white paper towel.

If cleaned parts are not bonded subsequently cover them in order to prevent new contamination. If the time between cleaning and further processing is more than two hours, repeat the treatment as described above.

Ideal application and surface temperature is between 15 °C and 25 °C.

Use only clean, white, lint-free paper towels.

Tightly reseal container immediately after each use.