Sika® Primer-209 D
Sika® Primer-209 D is a solvent-based black primer, which reacts with moisture and forms a thin layer. This layer acts as a link between substrates and adhesives.
Sika® Primer-209 D is specifically formulated for the treatment of bond faces prior to application of Sika’s 1-component Polyurethanes. This primer might provide excellent adhesion without previous activation step on certain plastic substrates.
Product Details
| Chemical base | Solvent-based Polyurethane solution | |
| Color (CQP001-1) | Black | |
| Solid content | 30 % | |
| Application temperature | 5 ─ 40 °C | |
| Application method | Brush, felt, foam applicator | |
| Consumption | depending on substrate porosity | 50 ml/m2 |
| Flash-off time | ≥ 15 °C < 15 °C maximum | 10 minutes 30 minutes 24 hours |
| Shelf life | 9 months A |
| CQP = Corporate Quality Procedure | A) stored in sealed container in up-right position in a dry place at ≤ 25 °C |
IMPORTANT NOTE
Sika® Primer-209 D is a moisture reactive system. In order to maintain product quality it is important to reseal the container with the inner plastic liner immediately after use. Once the surface pre-treatment operation is completed, the cap has to be screwed on.
Dispose the product of approx. one month after opening if used frequently or after two months in case of infrequent use.
If gelling, separation or a significant increase in viscosity is noted, discard the primer immediately.
Never dilute or mix this product with any other substances.
If used on transparent or translucent substrates such as plastics, etc., an adequate UV protection is mandatory.
Application
METHOD OF APPLICATION
Surfaces must be clean, dry and free from grease, oil, dust and contaminants.
Adhesion on substrates may be improved by adding and/or combining pre-treatment processes such as scuffing, cleaning and activating.
Application
Shake the Sika® Primer-209 D can very thoroughly until mixing ball rattles freely. Continue shaking for another minute and apply a thin but covering coat with a brush, felt or foam applicator.
Ideal application and surface temperature are between 15 °C and 25 °C.
Sika® Primer-209 D has to be applied once only. Care must be taken to ensure that this single application gives adequately dense coverage. Consumption and method of application depend on the specific nature of the substrates. Tightly reseal container immediately after each use.