Sika® InjectoCem-190

Micro cement injection grout

Image not available

2-part, mineral injection grout based on microcement binders with added corrosion inhibitors (d95 < 9.5 μm).

  • Structural grouting of cracks
  • Corrosion protection of embedded reinforcement
  • Deep penetration of narrow cracks in concrete and mortar
  • Good flow properties

Find this product in your country

Go

Overview

Areas of Application

  • Injection of Sika® Injectoflex® Systems Typ DI-1 and SikaFuko® injection hoses
  • Filling of voids
  • Final, rigid, cementitious sealing of cracks while simultaneously treating corroding or corrosion-prone reinforcing steel in concrete and mortar
 

Advantages

  • Structural grouting of cracks
  • Corrosion protection of embedded reinforcement
  • Deep penetration of narrow cracks in concrete and mortar
  • Good flow properties

Packaging

Part A:2 * 2.50 kg (Bag)Powder component
Part B:3.25 kg (PE-Bidon)Liquid component
Part A + B:8.25 kg (Pail)Ready mix unit

Product Details

Composition

Modified micro cement

Shelf life

In unopened original packaging: 12 months from date of production

Storage conditions

The product must be stored in original, unopened and undamaged sealed packaging in dry conditions at temperatures between +5 °C and +30 °C. Always refer to packaging.

Density

Part A + B:

~ 1.70 kg/l (+20 °C)

Viscosity

~ 100 mPa·s

(+20 °C)

Compressive strength

1 day:~ 30 MPa
7 days:~ 35 MPa
28 days:~ 37 MPa

Modulus of elasticity in compression

28 days:

~ 9 600 MPa

Tensile strength in flexure

28 days:

~ 2 MPa

Application

Mixing ratio

Part A : B:

1 : 0.65 (by weight)

Ambient air temperature

Min. +5 °C, max. +35 °C

Substrate temperature

Min. +5 °C, max. +35 °C

Pot Life

~ 1 hour

Keep in movement when not in use.

Yield

Pre-batched unit of 8.25 kg gives:

~ 5 l of injection grout

SUBSTRATE PREPARATION

The substrate must be sound, clean, free of oil and grease, old coatings and other contaminations.


For good adhesion, pre-treat the substrate with high pressure water or mechanically.


Use air pressure to remove dust from cracks.

MIXING

Sika® InjectoCem-190 is delivered in two precisely matched components. If required, a maximum of 0.2 l water can be added.


Place the liquid part B in a suitable mixing vessel. Mix with colloidal mixer at approx. 2 800 rpm and add the powder part A slowly and continuously. Mix the suspension thoroughly for at least 3 minutes.


Subsequently, pour the injection material directly into the pump or keep ready in a clean container.

CLEANING OF EQUIPMENT

Clean tools with water immediately after use. Hardened material can only be removed mechanically.